|
 |
ULTRABOND SPA - 5400
High Strength Segmental Pre-Cast Adhesive
| Description:
| Ultrabond SPA - 5400 is a two component 100% solids epoxy, solvent free, high strength, high modulus, moisture insensitive, non-sag paste epoxy adhesive. Formulated for use to bond pre-cast segmental box girders, bridge and other segmental construction. It is an excellent choice for any application where bonding concrete to concrete is required.
|
|
Uses and
Advantages:
| The 1:1 ratio is easy and convenient to mix.
Moisture insensitive during and after cure.
Concrete gray color when mixed.
Non-sag paste formula.
|
|
| Packaging:
| Ultrabond SPA is available in 1 gallon, 2 gallon, and 10 gallon kits.
| Coverage: |
1 Gallon yield 231 cu. in. of epoxy
1.8 cu. in. = 1 fl. oz. |
|
COVERAGE
Thickness
(1000 mils = 1 in.) |
Coverage/Gallon |
| 1/4" = 250 mils |
6.4 sq. ft. |
| 3/16" = 187 mils |
8.5 sq. ft. |
| 1/8" = 125 mils |
12.8 sq. ft. |
| 1/16" = 62.5 mils |
25.5 sq. ft. |
Manufactured In The U.S.A. by ULTRABOND
A Division of U.S. Anchor
| How To Use:
| BULK USE: Pre-mix each component "A" and "B" separately. Then mix all of part "A" with all of part "B" until a uniform gray color with no streaks is achieved. Mix with a drill on low speed (400 rpm) for a minimum of three minutes. Make sure to scrape the sides and bottom to thoroughly mix all contents. Mix the epoxy in 1:1 proportions. Mix only the quantity that can be used within the pot life of the adhesive. Read and follow the complete instruction guide for anchoring and doweling with bulk adhesives.
|
TECHNICAL DATA FOR ULTRABOND SPA - 5400
| Storage Conditions |
|
below 90° F |
|
| Consistency/Viscosity (@90°F) |
ASTM C881 |
Non-Sag Paste |
|
| Temperature Range |
|
55° F - 85° F |
|
| Mixing Ratio A:B (Volume) |
|
1:1 |
|
| Gel Time (1 gallon @ 78° F) |
ASTM C881 |
33 minutes 1 |
|
| Contact Time: Thin film (1/16" @ 70° F) |
|
2 Hours 1 |
|
| Bond Strength (2 day Cure @ 77° F) |
ASTM C882 |
>1,000 psi |
|
| Compressive Yield Strength (12 hour Cure @ 77° F) |
ASTM 695 |
5,000 psi |
|
| Contact Yield Strength (2 day Cure @ 77° F) |
ASTM D638 |
>1,250 psi |
|
1. Gel and Bolt Up Times lengthen as temperatures decrease and shorten as temperatures increase.
|
|
